PRINTED IN U.S.A.FORM NO. 769-00089A.fm(10/2002)Operator’s ManualIMPORTANT: Read safety rules and instructions carefully before operating equipment.TR
10SECTION 4: OPERATING YOUR LOG SPLITTER Gas and Oil Fill-Up• Service the engine with gasoline and oil as instructed in the engine manual packed with
11• To lock the beam in the vertical position, pull out on the vertical beam lock and rotate it to secure the beam. See Figure 13.• Stand in front of
12SECTION 5: ADJUSTING YOUR LOG SPLITTERWedge Assembly AdjustmentAs normal wear occurs and there is excessive “play” between the wedge and beam, adju
13kerosene whenever any repair work is performed on the tank, hydraulic pump or valve. For this job, contact your nearest service dealer. Hydraulic Fi
14SECTION 7: STORING YOUR LOG SPLITTERPrepare your log splitter for storage at the end of the season or if the log splitter will not be used for 30 d
15Hydraulic TroubleshootingNOTE: For repairs beyond those listed here, contact your nearest authorized service center.Problem Cause RemedyCylinder rod
16SECTION 9: PARTS LIST FOR MODEL LS33890474248478941874638394036371516926613252732303386127879802221232420111092728312981465663434445828384856865666
17Model LS338 Ref. No.Part No. Part Description1.781-0686 Log Tray Bracket3.781-0682 Log Tray4.710-3097 Carriage Bolt 3/8-16 x 1.05.719-0550 Wedge Ass
MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used
2TABLE OF CONTENTSContent PageImportant Safe Operation Practices... 3Assembling Your L
3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESGeneral Practices1. Read, understand, and follow all instructions on the machine and in the manual(s) b
4equipment. move machine to another area. Wait 5 minutes before starting the engine.i. Never store the machine or fuel container inside where there is
5SECTION 2: ASSEMBLING YOUR LOG SPLITTERUnpacking from Crate• Pry top, sides, and ends off the crate. Set panels aside to avoid tire puncture or pers
6• Insert hex bolts through top holes in jack stand mounting brackets and holes in jack stand. Secure with lock washers and hex nuts. See Figure 3.• I
7Attaching Beam • For shipping purposes, the pressure hose is attached to the pump on the engine and to the control valve on the cylinder.• Disconnect
8• Remove the protective cap from the fitting on top of the filter head. Attach the end of the hose to the fitting on top of the filter. Place the hos
9SECTION 3: KNOW YOUR LOG SPLITTERCompare the illustration in Figure 13 below with the controls on your log splitter, and get familiar with its feat
Kommentare zu diesen Handbüchern