Troy-bilt Two-Stage Snow Thrower Bedienungsanleitung PDF herunterladen (Seite 18)

Maintaining

Your Snow

Thrower

WARNING

Always stop engine,

disconnect spark

plug, and ground

against engine before

cleaning, lubricating

or doing any kind

of maintenance or

adjustments on your

machine.

Augers

• The augers are secured to the spiral shaft with two

shear pins and cotter pins. If the auger should strike

a foreign object or ice jam, the snow thrower is

designed so that the pins may shear.

• If the augers will not turn, check to see if the pins

have sheared. One set of replacement shear pins

has been provided with the snow thrower. When

replacing pins, spray an oil lubricant into shaft before

inserting new pins.







Drive Belt Replacement

To remove and replace your snow thrower’s auger

belt, proceed as follows:

1. Remove the plastic belt cover on the front of the

engine by removing the two self-tapping screws.

• Drain the gasoline from the snow thrower, or place

a piece of plastic under the gas cap.

• Carefully pivot the snow thrower up and forward so

that it rests on the auger housing.

2. Remove the frame cover from the underside of the

snow thrower by removing four self-tapping screws

which secure it.

3. a. Grasp the idler pulley and pivot it toward the right.

b. Roll the auger belt off the engine pulley.

c. Lift the drive belt off engine pulley.

4. Slip the drive belt off the pulley and between friction

wheel and friction wheel disc.

• Remove and replace belt in the reverse order.







Figure 24

Figure 25

Figure 27

Figure 28

Figure 26

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

Troy-bilt Two-Stage Snow Thrower Bedienungsanleitung Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Troy-bilt Two-Stage Snow Thrower